Overview
The material decides more than the price
Alloy choice affects machinability, corrosion resistance, strength, weight, finishing and lead time. The same part in 6061 and 7075 aluminum can differ in cost, anodizing response and dimensional stability.
We stock or source the common grades and will tell you when a substitution is safe, when it changes the finish, and when it is a bad idea.
- Aluminum 6061 and 7075
- 303, 304 and 316 stainless
- Titanium Grade 5
- Brass C360
- Cold rolled steel
- Engineering plastics
- Co-Netic alloys on request
Common material families
Comparison
Material selection at a glance
| Material | Strengths | Limitations | Typical parts |
|---|---|---|---|
| Aluminum 6061-T6 | Easy to machine, anodizes well, good corrosion resistance | Lower strength than steel | Housings, brackets, covers |
| Aluminum 7075-T6 | High strength aluminum | Less corrosion resistant, higher cost | Aerospace-style structural parts, molds |
| 304 stainless | Good general corrosion resistance | Work hardens, slower to machine | Food and medical equipment parts |
| 316 stainless | Resists chlorides and harsh environments | Higher cost, harder to machine | Marine, chemical and medical parts |
| Titanium Grade 5 | High strength-to-weight, corrosion resistant | Slow machining, high material cost | Medical, aerospace-style and high-end industrial parts |
| Brass C360 | Excellent machinability and finish | Lower strength, material cost varies | Fittings, connectors, electrical parts |
| Cold rolled steel | Strong, economical, weldable | Needs plating or coating | Fixtures, brackets, machine frames |
| POM / PEEK | Low friction, chemical resistance, light | Moves with temperature, lower strength | Insulators, guides, wear parts |
Documentation
Certificates and traceability
Material certificates are available for every lot. If your customer or auditor needs a specific mill, heat number or country of origin, tell us at quoting and we will confirm availability.
For customer-supplied material, we machine what you send and record the condition we receive it in. We do not certify material we did not buy.
Specifying
How to specify material
Use the standard designation and temper: 6061-T6, 304 stainless, Ti-6Al-4V, C36000. If the drawing only says aluminum or stainless, we will ask which grade before quoting, because the price and the finish depend on it.
If the material is critical to a certification, put it on the drawing and in the purchase order, not only in an email.
- Alloy and temper
- Surface condition
- Certificate requirement
- Heat treatment or stress relief
- Country of origin if required
- Substitution rules