Overview
Permanent, without a label
Laser marking burns or anneals the surface to create a permanent mark. It is used for part numbers, logos, serials, UDI-style codes and orientation marks that must survive cleaning and use.
Contrast depends on the material and finish. Anodized aluminum marks well; bare machined aluminum, stainless and plastics behave differently. A sample is the only reliable way to approve contrast.
- Part numbers and serials
- Logos and graphics
- Traceability marks
- Orientation and assembly marks
- Anodized aluminum
- Stainless and plastics
Specifying
Placement and design
Send the artwork as vector or high-resolution files, the exact location, the size and any depth or contrast requirement. Marking on a curved or finished surface needs a fixture and a test.
Do not place a mark on a sealing face, a sliding surface or a thread unless the drawing says so. A mark is permanent; a mistake is scrap.
- Vector artwork
- Exact location and size
- Contrast or depth
- Surface finish before marking
- Avoid sealing and sliding faces
- Sample approval
Typical marks
Applications
Typical parts
Machined housings, brackets, shafts, instrument panels and anodized covers. Marking is often combined with anodizing, and the order matters: mark before or after finishing depending on the contrast you want.
Marking is quoted with the finishing package; placement and contrast are approved on a sample.