Overview
Most parts start with 6061
6061-T6 is the default because it machines well, anodizes evenly and costs less. 7075-T6 is stronger, but it is less corrosion resistant and less forgiving on finish. The choice is usually about load, weight and environment, not preference.
If a part is not highly stressed, 6061 is usually the better total cost. If strength or weight is the constraint, 7075 may be worth the premium.
Comparison
6061-T6 vs 7075-T6
| Property | 6061-T6 | 7075-T6 |
|---|---|---|
| Strength | Medium | High |
| Machinability | Excellent | Good |
| Corrosion resistance | Good | Lower |
| Anodizing | Even, predictable | Possible, less uniform |
| Weldability | Good | Poor |
| Cost | Lower | Higher |
| Typical use | Brackets, housings, fixtures | Structural parts, molds, high-load components |
Decision
How to decide
Start with the load case and the environment. If the part sees high stress or needs to be as light as possible, 7075 may be justified. If it is a cover, a bracket or a housing, 6061 is usually enough.
Then consider finishing. A cosmetic anodized part is easier in 6061. A structural part that will be painted or protected can use 7075 without the same cosmetic risk.
- Load and safety factor
- Weight target
- Corrosion environment
- Cosmetic anodizing
- Welding required
- Budget
Cost
Cost and availability
7075 costs more per kilogram and can be less available in some thicknesses. It also machines well, but the higher strength does not always translate into a lower total cost.
We quote both when the choice is close, so you can compare the finished part rather than the material price alone.