Material
When strength matters more than finish
7075-T6 is a high-strength aluminum alloy used for structural parts, molds and components that see serious load. It machines well, but it is less forgiving than 6061 on corrosion and anodizing.
For a part that needs high strength and low weight, 7075 can replace steel and remove weight. For a cosmetic housing, 6061 is usually the better answer.
- Higher strength than 6061
- Good machinability
- Lower corrosion resistance
- Anodizing can be less uniform
- Higher material cost
- Common in structural and mold work
At a glance
| Property | What it means for your part |
|---|---|
| Strength | High for aluminum; often used in structural parts |
| Machinability | Good, but less forgiving than 6061 |
| Corrosion | Lower than 6061; protect exposed surfaces |
| Anodizing | Possible, but color and corrosion performance vary |
| Cost | Higher material cost |
| Typical use | Structural parts, molds, high-load components |
Process notes
Machining and finishing
7075 cuts cleanly with sharp tools and good chip evacuation. Thin sections can distort, and the higher strength does not remove the need for a sensible fixture.
Because corrosion resistance is lower than 6061, exposed parts usually get anodizing or a coating. Tell us the service environment so the finish is chosen for it, not just for appearance.
Grades and finishes we quote
Applications
Typical parts
Typical parts include structural brackets, mold components, high-load fixtures, racing and drone components, and parts where a small weight saving matters.
If the part is highly stressed, tell us the load direction. Material choice and grain direction can matter as much as the alloy.
7075 is not a drop-in replacement for 6061: corrosion and anodizing behavior change.