Overview
There is no single price per hour
Two parts with the same weight can differ by a factor of five. The price is built from setup, programming, material, cycle time, tolerance, finishing, inspection and freight. A quote that only states a number hides the assumptions behind it.
This guide explains the components so you can compare quotes fairly and see which design changes actually reduce cost.
Cost structure
What is in the price
| Component | What it covers | What moves it |
|---|---|---|
| Setup and programming | Fixture, tooling, CAM, first article | Number of setups, complexity, tolerances |
| Material | Bar or plate, certificate | Alloy, size, availability, scrap |
| Cycle time | Machine time per part | Geometry, material, tolerance, finish |
| Finishing | Anodizing, coating, marking | Type, color, masking, cosmetic requirements |
| Inspection | First article, in-process, final report | Critical features, documentation, sampling |
| Packaging and freight | Protection, documents, transport | Destination, weight, speed, Incoterm |
Cost drivers
The features that raise cost
Tight tolerances, deep pockets, thin walls, sharp internal corners, fine surface finishes and multiple faces all add time or risk. So does a material that work hardens or wears tools quickly.
A tolerance that is tighter than the function requires is the most common way to overpay. The second is a design that needs three setups when one would do.
- Tolerances tighter than needed
- Deep pockets with poor tool access
- Thin walls that distort
- Sharp internal corners
- Multiple setups and re-fixturing
- Cosmetic finishes on hidden faces
- Rare alloys or oversized stock
Method
How we build a quote
Read the drawing
Identify datums, critical features and the finish that matters.
Choose the process
Machine, material and fixturing that fit the quantity.
Estimate cycle time
Programming, setups, cutting time and inspection.
Add finishing and freight
Finishing, packing and the agreed Incoterm.
State the assumptions
Material, quantity, tolerance and lead time, in writing.
Reduction
How to reduce cost without hurting the part
Relax tolerances that do not control fit or function. Combine features into fewer setups. Use a standard alloy and a standard stock size. Move cosmetic requirements to the faces that are actually visible. Ask for a quote at two quantities; the setup cost is spread differently.
If a part is still a concept, ask for a DFM review before the design freeze. Moving a hole or changing a corner radius is cheap on screen and expensive after the first article.
- General tolerance plus critical callouts
- Fewer setups
- Standard material and stock
- Cosmetic faces only where visible
- Quote at two quantities
- DFM before design freeze
Comparison
How to compare two quotes
Compare the assumptions, not just the total: material grade, quantity, finish, inspection, packing, Incoterm and lead time. A quote that excludes finishing or freight is not cheaper; it is incomplete.
Ask what would change the price. A supplier who can explain the cost drivers is easier to work with than one who only sends a number.
Any price ranges you see online are not a quote. The part, the quantity and the destination decide the number.